自由电子激光振荡器的二维数值模拟

在柱二维坐标系中,用数值计算方法求解了摇摆器内电子模拟方程组、光场方程组和无源区(不含摇摆器区)经非自适应方法变换后的无源旁轴波动方程并设计了相应的程序R_2D。用该程序计算的数值结果表明,在有源条件下二维数值模拟结果与高斯光束近似下的数值模拟结果符合较好;取完全相同的计算条件R-2D程序与洛斯阿拉莫斯实验室(LANL)的FELEX程序的计算结果符合较好;初步认为LANL实验数据的物理图象合理,数值结果基本可信;最后给出北京自由电子激光器(BFEL)的一些物理数据。     

向量值函数的Mcshane积分

本文讨论了向量值函数的Ｍｃｓｈａｎｅ积分的性质．例如收敛定理和原函数的性质等．     

高考预效度的混合估计

用传统的预测效度估计法估计高考预测效度，其估计值往往偏低。为此，本文应用回归分析中混合估计理论提出了高考预测效度的混合估计。这种估计是预测效度的无偏估计，并解决了预测效度估计值偏低的问题。     

CLIFFORD MARTINGALES Φ-EQUIVALENCE BETWEEN S（f） AND f^＊

ＣＬＩＦＦＯＲＤＭＡＲＴＩＮＧＡＬＥＳΦ－ＥＱＵＩＶＡＬＥＮＣＥＢＥＴＷＥＥＮＳ（ｆ）ＡＮＤｆ￥ＬＯＮＧＲＵＬＩＮ；ＱＩＡＮＴＡＯ（ＩｎｓｔｉｔｕｔｅｏｆＭａｔｈｅｍａｔｉｃｓ，ＡｃａｄｅｍｉａＳｉｎｉｃａ，Ｂｅｉｊｉｎｇ１０００８０，Ｃｈｉｎａ．）...     

Expert systems for HPLC in biochemistry—The knowledge base for selection of HPLC column system in the separation of amino acids,peptides and proteins

The strategy of expert system for high performance liquid chromatography was discussed, the attentions are mainly placed on the knowledge base for selection of column system, separation modes and detection modes in the analysis of amino acids, peptides and proteins.     

All solid-state sum-frequency generation of 1.12-W continuous-wave laser at 588 nm

A new resonator design for doubly resonant continuous-wave (CW) intracavity sum-frequency mixing (SFM) is reported. 1.12 W of coherent radiation at 588 nm is generated by mixing 1062-nm Nd:GdVO4laser and 1319-nm Nd:YAG laser. The optical-to-optical conversion efficiency is up to 3.7%.     

反向驱动的异质结有机薄膜电致发光

成功制备了结构为ITO／PDDOPV／PPQ／Al的异质结聚合物发光二极管。该器件在正反向偏压下均可发光。在正向偏压下的光发射主要来自PDDOPV，但在反向偏压下的光发射则包括来自PPQ的蓝光发射和PDDOPV的黄光发射。蓝光强度与黄光强度的比值随着反向偏压的增加而增加，当反向直流电压分别为22V、24V、26V、28V时，其电致发光光谱中PPQ与PDDOPV的峰高比IPPQ／IPDDOPV分别为1．092、1．329、1．605、2．046。换句话说，该器件的发光颜色是压控可调的，这对实现彩色显示是极为有利的。分析了在反向偏压下的发光机理以及IPPQ／IPDDOPV受电压控制的原因。     

有效点、弱有效点和真有效点的锥刻画

利用集合在某点的相依切锥、法向锥和可行方向锥等研究向量优化问题的有效点、 弱有效点和真有效点的特征,对局部有效点、局部弱有效点和局部真有效点与集合的各 锥之间的关系作了刻画.     

Characterization of ceramic PVD thin films on AZ31 magnesium alloys

Ceramic thin films have been widely used to protect the metal substrate as coatings in the past years. In order to improve the poor corrosion resistance of AZ31 magnesium alloy, the study in this paper used the electron beam evaporation method to prepare ceramic PVD films on its surface with TiO₂ and Al₂O₃ as donors, respectively. Atomic force microscopy (AFM), scanning electron microscope (SEM), energy dispersive X-ray spectrometer (EDS), Auger electron spectroscopy (AES) and X-ray diffraction (XRD) were used to investigate the surface morphology, composition and microstructure of the thin films. Both films deposited on AZ31 took on compact top surface morphologies and grew as amorphous structures on substrate. AES test not only showed that films compositions deviated the standard stoichiometric ratios, but also found that element Mg diffused into films and existed as magnesium oxide in the TiO_x film as well as the AlO_x film. In the electrochemical corrosion test, the AlO_x coating on AZ31 exhibited the largest electrochemical impedance in a 3.5% NaCl solution. But it did not show better corrosion resistance than others for the poorer adhesion. Even if its thickness was small, the TiO_x coating on AZ31 exhibited the best corrosion resistance in this study. According to the observation and analysis, the damage of these films on AZ31 in aggressive solutions was mainly due to the existence of pores, microcracks, vacancies and poor adhesion between coating and substrate.     

Micromagnetic analysis of transition noise for high-density perpendicular recording

In this paper, specific issues related to high-density perpendicular magnetic recording processes, such as transition noise properties and cross-track correlation lengths, were investigated with the help of micromagnetic analysis. The effects of media parameters were taken into consideration, including intergranular exchange coupling, and exchange distribution, irregular grain shapes, magnetization saturation distribution, and anisotropy distribution. The micromagnetic simulation results showed that the effect of anisotropy distribution on transition noise is more significant than magnetization saturation distribution, and it is crucial to reduce this effect to achieve a high signal-to-noise ratio. Additionally, a new method to further estimate the partial erasure threshold was proposed to approximate the partial erasure effects, and the relation between the microtrack jitter and total track jitter was investigated.